How To Change Air Filter On 2015 Sienna

Your engine needs air to exhale in gild to operate optimally. If your air filter is starting to become clogged, information technology can bear on gas mileage, acceleration, as well as potentially allow sand and grit particles into the engine, increasing wear, and decreasing engine life… not skilful!

In this quick picture show guide, we'll go through the steps to chop-chop and easily change the engine filter in a Toyota Sienna.

When yous purchase through links on our site, we may earn an affiliate commission – at no toll to you.

How long does information technology accept to change an Engine Air Filter?

This is a very quick maintenance item and should take less than ten minutes.

How oftentimes should yous change the Engine Air Filter in a Toyota Sienna?

The engine air filter in a Toyota Sienna should be changed every 15,000 to thirty,000 miles, and every 10,000 in extreme conditions. If yous live on a dirt route, this is considered extreme weather due to all the extra sand and grit that your engine is pulling in every fourth dimension y'all drive!

Tools and Supplies Needed:

10mm socket wrench
Engine Air Filter (Use the following tabular array to cull the correct office number)

Sienna			Engine Air Filter
Twelvemonth	2.5L (4-Cyl)	2.7L (4-Cyl)	iii.3L (6-Cyl)	three.5L (6-Cyl)
2021	CA10755			CA10755
2020				CA10755
2019				CA10755
2018				CA10755
2017				CA10755
2016				CA10755
2015				CA10755
2014				CA10755
2013		CA10755		CA10755
2012		CA10755		CA10755
2011		CA10755		CA10755
2010				CA9360
2009				CA9360
2008				CA9360
2007				CA9360
2006			CA9360
2005			CA9360
2004			CA9360

Steps to Change the Engine Air Filter in a Toyota Sienna

The offset step is to pop the hood and locate the filter housing. In this 2006 Toyota Sienna, it is simply aft of the battery.

Employ a 10mm socket with extension to remove the bolt from the front of the housing.

Note, it is a captured bolt, meaning that you can loosen it all the manner and it will remain attached to the housing and then you won't loose it.

Loosen the 10mm commodities on the back of the housing.

Next, lift the filter housing up to expose the quondam engine air filter. The housing rotates on 2 plastic pivot points located along the left side of the housing. You lot do not need to remove the housing from those pin points to replace the filter, simply if you desire to in order to get easier access, tilt and elevator up on the housing to disengage the pivot hinges.

Slide out the old air filter. Now is also a expert fourth dimension to look into the housing and clean out or vacuum out any dirt or debris that has accumulated there.

Compare the onetime and new filter to verify that you accept the correct sized replacement.

Slide the new filter into the housing in the same orientation as the old one. Note that oft one of the corners is more pointed than the others. This can help give an index to indicate the correct orientation of the filter.

Toyota Sienna Engine Air Filter Replacement

After the new filter is seated properly inside the housing, close the housing and re-tighten the 10mm bolts.

Conclusion

That's it, it is a really easy maintenance item. I've included the part numbers again here for reference:

Sienna			Engine Air Filter
Year	ii.5L (4-Cyl)	ii.7L (4-Cyl)	3.3L (vi-Cyl)	three.5L (6-Cyl)
2021	CA10755			CA10755
2020				CA10755
2019				CA10755
2018				CA10755
2017				CA10755
2016				CA10755
2015				CA10755
2014				CA10755
2013		CA10755		CA10755
2012		CA10755		CA10755
2011		CA10755		CA10755
2010				CA9360
2009				CA9360
2008				CA9360
2007				CA9360
2006			CA9360
2005			CA9360
2004			CA9360